V-bars at the top
Formwork
Pedestal Base Formwork hole which should be ready for concrete. It is held together with H-bars at the top and bottom on the corners while the centers are held together with V-bars at the top with pins and wedges at the bottom. First the constructio floor will be made.
Agatec 220HV
Horizontal Self Leveling Rotary Laser with Semi Automatic Vertical Mode provides me to complete the gauge application. It will level itself within its 5.7 Degree self leveling range and start spinning.
Measurement
measure out lengh en width standard tools and laser measuring device.
Because the soil could easily collapse, 18mm (0,7 inch) woodplate has been used to mold wooden partitions.
Water
Heavy rain after some snow last weeks causes overflow.
Adjusting
the plates to the poles
Finished work
Next step:
Common rebars, made of unfinished tempered steel 10mm. This is what I call ‘The Braid’. It’s concrete reinforcement steel or rebar.
Mud
Boots in the mud...
Tarpaulin
The beste way to cover the bottom is to use colloquially tarp, 6x8m a large sheet of strong, flexible, water-resistant material.
Bending
The rebars nets with a home-made tool (piece of iron with a 12mm hole)
Cutting with a rebar claw. You can see it’s been built up in layers
Pumping
brackish water, ground water level is about 60cm (12'')
Next:
pouring concrete
Construction floor
4m3 (140ft3) concrete will be poured, and the construction floor will be made.
New foundation
Preperations: After this the base of NCRT will have it’s new foundation and will finally be stabilized!
Next:
In total the construction floor will be about a foot or 20cm thick, and on top of that I will put the rotorbase.
Construction floor
Finally the hole will be poured full with 16m3 concrete. (565 ft3)
Construction floor rebars nets
double rebar nets vertical
Cutting
obstructive empty sewer pipe spare tube has been cut. Underneath the 1.5/8 and 7/8 coaxial feedlines which do not need depravation.
